What sizes does this cover?

The Socket & Wrench Size pack covers standard metric hex bolts from M3 to M36 and imperial hex bolts from 1/4" to 1-1/2". These are the most common sizes in hardware stores and automotive work.

Are these sizes guaranteed correct?

Sizes are based on ISO and SAE standards for standard hex head bolts and nuts. Actual fasteners vary by manufacturer, grade, and application. Always verify with the fastener when precision matters.

What about Torx, spline, or specialty fasteners?

This tool covers hex head fasteners only. Torx, spline, 12-point, and other drive types are not yet supported.

Can I use the nearest imperial socket on a metric bolt?

In a pinch it may work, but risks rounding the fastener head. Use the correct socket whenever possible. Related values shown are for reference, not substitution.

Will more packs be added?

Yes. Pilot Hole, Tap Drill, and Metric/Imperial conversion packs are planned. The architecture supports new reference sets without changing the app.

1-1/4" Bolt Torque — 1120 ft-lbs (1519 N·m)

Reference Grade 5 torque for a 1-1/4" hex bolt: 1120 ft-lbs (1519 N·m). Lubricated: 840 ft-lbs (1139 N·m).

Result

Answer

1120 ft-lbs (1519 N·m)

Standard

Buy1-1/4 bolt Torque wrench Wrench set

Torque (dry)1120 ft-lbs / 1519 N·m

Torque (lubricated)840 ft-lbs / 1139 N·m

Bolt GradeGrade 5

Thread1-1/4"-7 UNC

Recommended Drive1/2" drive

A 1-1/4"-7 UNC Grade 5 bolt should be torqued to 1120 ft-lbs (1519 N·m) dry. Lubricated torque is approximately 840 ft-lbs (1139 N·m). Always use a calibrated torque wrench.

Note

Reference value from published fastener data. Always verify with the fastener manufacturer for critical applications.

Related Sizes

← 1-1/8" bolt 1-3/8" bolt →

About 1-1/4" Bolt Torque

A 1-1/4" hex bolt (Grade 5): reference torque is 1120 ft-lbs (1519 N·m), with a lubricated estimate of 840 ft-lbs (1139 N·m). Standard thread is 7 TPI (UNC coarse) or 12 TPI (UNF fine). Use a 1/2" drive torque wrench. Actual torque depends on thread condition, lubrication, and joint design — always verify with the fastener manufacturer.

← Look up another bolt size